Rule 10-6UL Marine Rule 2000 Marine Bilge Pump (2000-GPH, 12-Volt, UL Listed with 6-Foot Wire Leads)

You looking to find the "Rule 10-6UL Marine Rule 2000 Marine Bilge Pump (2000-GPH, 12-Volt, UL Listed with 6-Foot Wire Leads)" Good news! You can purchase Rule 10-6UL Marine Rule 2000 Marine Bilge Pump (2000-GPH, 12-Volt, UL Listed with 6-Foot Wire Leads) with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

Price: $122.42 $105.00   

Product Feature

• 3 Year Warranty

Product Description

Rule 2000
Non-Automatic 12v, UL listed w/ 6' wire leads

Engineered to commercial standards. The Rule 2000 is the best selling high capacity submersible bilge pump in the world. 1-1/8" (28.6mm) discharge outlet.

FEATURES

• Fully Submersible
  
• Easy clean snap lock strainer
  
• Silent and vibrationless operation
  
• Anti-airlock protection
  
• Compact, efficient long life motor
  
• Ignition protected
  
• No burn-out when run dry
  
• Rust and Corrosion protection
  
• Used by leading boatbuilders worldwide
  
• marine grade blocked wiring

Rule 10-6UL Marine Rule 2000 Marine Bilge Pump (2000-GPH, 12-Volt, UL Listed with 6-Foot Wire Leads) Review

No one wants to worry that their boat, perhaps in a slip two hours away, is slowly taking on water because the bilge pump has failed. Well, you can sleep soundly with the reliable Rule 2000 (10-6UL) bilge pump on the job.

Over the years, I have replaced perfectly good Rule pumps with some other brand of "New Concept" bilge pump. Well, they all eventually packed it in and wound up in the marina dumpster. So, it was back to Rule for me.

The Rule 10-6 UL is non-automatic and must be paired with a float switch or sensor. The Rule Super Switch float switch is an ideal choice. I have never had one of these fine switches leak or otherwise fail. In addition to the float switch, you will need a "remote" (panel-mounted) ON/OFF/AUTO switch. Pick any of the Rule remote switches sold by Amazon to suit your mounting location.

I have a very deep bilge in the keel of my sailboat, 3 feet or so. The 6-foot wire leads of the 10-6 UL made a corrosion - free installation easy, especially when paired with the waterproof connections of the Super Switch.

Oddly, the leads on the Super Switch are shorter than the pump wires. If you have deep bilges, it's important to use liquid sealer and/or shrink wrap on the switch-wire splices. I also solder the switch connections with "radio" solder, which is made with a non-acid flux. NEVER use regular "plumbing" solder, which has corrosive acid in its flux.

This is a big pump. Before you purchase it, make sure that your bilge has room for it and the Super Switch (which is also rather large.) Because it is physically large, I have found that the Rule will continue to pump even when it encounters some minor debris (but remember, good seamanship includes keeping pristine bilges.)

Most of the consumer Reviews tell that the "Rule 10-6UL Marine Rule 2000 Marine Bilge Pump (2000-GPH, 12-Volt, UL Listed with 6-Foot Wire Leads)" are high quality item. You can read each testimony from consumers to find out cons and pros from Rule 10-6UL Marine Rule 2000 Marine Bilge Pump (2000-GPH, 12-Volt, UL Listed with 6-Foot Wire Leads) ...